全部

1·Cycle polymer flooding method can reduce injection pressure.

周期注聚方式可以降低注入压力。

2·The injection pressure, timing, duration and rate depend on the engine speed and load.

喷油压力、喷油始点、喷油持续角和喷油率均取决于柴油机转速和负荷。

3·Finally, the injection pressure for the earthquake triggered by injecting water is considered.

最后，对注水地震的注水压力进行了讨论。

4·Influence of injection pressure and fuel temperature for standard fuel consumption was studied.

研究了喷油器开启压力和试验油温度对标准油量的影响；

5·The injection pressure rose, the injectivity profile and interlayer contradiction was modulated.

水井注入压力升高，吸水剖面得到调整，层间矛盾得到改善；

6·The injection pressure is commonly described as the surface pump pressure required to achieve injection.

注入压力普遍地是指实现注入所需的地面泵压。

7·Injection pressure in one of the major factors effecting the results of development of sandstone reservoirs.

注水开发的砂岩油田，注水压力的高低对油田开发效果有很大的影响。

8·Water injection efficiency depends on whether the injection pressure is high or low in water injection Wells.

注水井注水压力的高低直接影响水井的注水效率。

9·The influences of injection pressure and injection temperature, two important injection parameters, were studied.

研究了注射压力和注射温度这两个重要的注射参数对注射坯体质量的影响。

10·Anew forecasting method of wellhead injection pressure for polymer flooding is established based on Dupuit formula.

依据裘比公式建立了一种新的聚合物驱油井口注入压力预测方法。