全部

1·According to maximal pressure Angle and nomogram 4 or 5 determine the minimum CAM size.

按最大压力角和图线(4)或(5)决定凸轮最小尺寸。

2·It influences not only the pressure Angle of mechanism, but also the curvature of earn contoUrs.

它不仅影响机构的压力角，而且还影响其轮廓曲线的曲率半径。

3·Pressure Angle is never zero, the transmitted force always tends to push centers of the gear apart.

压力角不会是零，传动力总是倾向于把齿轮的中心分开。

4·The relationship of CAM with oscillating follower's pressure Angle and Basic dimensions were analyzed.

分析了摆动从动件盘形凸轮机构的压力角与基本尺寸之间的关系。

5·The new principle to measure the gear whole error with small pressure angle involute worms is presented.

提出了小齿形角渐开线蜗杆测量齿轮整体误差的新原理，阐明了其优点，并进行了原理论证和参数设计计算。

6·The relationship of cam with oscillating followers pressure angle and radius of basic circle were analyzed.

分析了摆动从动件盘形凸轮机构的压力角与基本尺寸之间的关系。

7·Generally, standard gear hobs are only used to machine gears with the same modul, pressure Angle as hobs themselves.

在一般条件下，标准齿轮滚刀只能加工与其模数、压力角相同的同制齿轮。

8·The author has derived a formula for the pressure Angle and a simplified formula for such a spatial four-bar linkage.

作者推导了该空间四杆机构中的压力角公式及其简化公式。

9·This paper presents a practical method to calculate the pressure angle at pitch cylinder, of gear drive with computer.

本文提出了一种利用计算机计算齿轮传动啮合角的简便易行的方法。

10·The available method for determining basic size of cam mechanism according to its allowable pressure angle is lack of appropriateness.

现有按许用压力角确定凸轮机构基本尺寸的方法欠妥。