全部

1·The bending Angle increases with an increase of the energy density.

增加能量密度，板料的弯曲角度显著增大。

2·This paper introduces how to obtain and assimilate the GPS bending angle.

文中介绍了如何获得及同化GPS折射角资料的原理。

3·In order to adjust the bending Angle, the T-type slide seat and bending press plate were used.

模具采用T形滑座与弯曲角两边的压板调节，从而达到在一定范围内调节弯曲角度的目的。

4·The reasons that the bending angle decrease with the number of irradiation are analyzed by using the built model.

用建立的模型分析了多次扫描过程中随扫描次数增加弯曲增量逐渐减小的原因。

5·The purpose of this paper is to probe into the impact of the bending angle of heat pipe on its thermal performance.

本文之主要研究目的为探讨热管弯曲角度其热传性能的影响。

6·As a result, the calculation proved that theoretical solutions were very precise in the range of little bending Angle.

理论与计算结果表明，在小抛掷角范围内，该方法有很好的计算精度。

7·Under the constant bending times, the biggest bending angle can be obtained with an optimal accumulative line energy value.

在扫描次数一定的情况下，存在一个最优的累积线能量使弯曲角达到最大；

8·The machine is specially designed for duct engineering. It is light weight, and is easy to move. The bending angle of products is small.

本机械是专为通风管道工程设计机械，具有重量轻，移动方便，压角角度小等优点。

9·At the same press bending Angle, the cross section distortion of the tubes decreases by increasing the distance between the die fulcrums.

在相同的压弯弯曲角度下，增大凹模支点的间距可以减小管坯截面的畸变。

10·The ANN model between the bending Angle and technological parameters is built by using the technology and sample data which has been acquired.

应用神经网络技术，并利用已经获取的加工样本数据，建立起工艺参数与折弯角之间的人工神经网络模型。