全部

1·The exposed surface of the structure shall be even, and shall be free from honeycombs, pitting surface, exposed reinforcing bars and cavities.

结构物外露的表面应平整，无蜂窝、麻面、露筋及空洞。

2·No honeycombs, pitting surface and cracks may exist on the surface of the waterproofing concrete along the bridge deck pavement, there shall be no cracks at the construction joints.

桥面铺装防水混凝土表面不得有麻面、蜂窝和裂纹，施工缝处不得有裂缝。

3·Test results showed that the optimized pickling process could clean oxide skin of weld surface in effect and improve pitting-resistance property greatly.

研究结果表明，采用本文中的酸洗工艺可以有效清除不锈钢焊缝表面的氧化皮，并改善其耐点蚀性能。

4·The pitting corrosion of the fresh stainless steel surface have been studied.

研究了不锈钢去膜表面在氯化镁介质中的点腐蚀现象。

5·Removing visible surface corrosion before pitting begins (such as during a C-check) helps prevent conditions that can lead to crack initiation.

在出现斑点之前去除可见的表面腐蚀(诸如c -检)有助于预防发生裂纹。

6·Failure: Pitting, cratering, or erosion of the surface. Obvious and significant deterioration.

失败：表面出现斑痕、凹或侵蚀，明显且重要的材料损毁。

7·The results show the method can effectively enhance uniform and pitting corrosion resistance of magnesium alloy surface, improve stability under moist atmosphere corrosion.

结果表明，该方法可以有效地改善镁合金表面耐全面腐蚀、 点蚀的性能，提高镁合金表面在温热潮湿环境下的稳定性。

8·The pitting critical potential of the fresh surface is lower than that of the surface covered by passive film.

去膜表面发生点蚀的临界电位低于膜覆盖表面发生点蚀的临界电位。

9·The results show, when pitting corrosion occurred on the brass surface, the polarization resistance of electrode was obviously decreased, and the corrosion potential being also obviously lowered.

结果表明，黄铜表面出现点蚀时，电极的极化电阻明显下降，腐蚀电位也明显降低。

10·The results showed that electrode wear rate was higher at beginning welds than later welds; pitting building at electrode surface accelerated electrode wear and invalidation.

结果表明初始焊接阶段电极磨损速率较大，点蚀加剧了电极磨损与失效。