全部

1·When the maximum heat flux density is acquired, the experiment confirms the groove surface size as follows: 0.

实验确定了获得最大热流密度时的微槽表面尺寸为槽宽、槽深以及槽间距分别为0。

2·At the same time, the mass flow rate and the heat flux density of each cross section of smoke flow were calculated as well.

同时，计算了烟气羽流各截面的质量流量和热流密度。

3·The calculation of the model reveals the distribution variation of flue gas concentration and heat flux density within the furnace.

模型计算揭示烟气温度和热流密度在炉膛内的分布变化。

4·The paper describes the measuring technique of infrared radiant heat flux density reached the surface or absorbed by the surface of spacecraft during thermal balance test.

文章介绍了在航天器热平衡试验中到达航天器表面或被其吸收的红外辐射热流密度的测量技术。

5·Also discussed is the effect of parameters such as in tube fluid Reynolds number (in the absence of fouling) and dimensionless heat flux density on the above mentioned increment number.

讨论了管内流体雷诺数(无污垢时)和无因次热流密度等参数对无因次熵产相对增加数的影响。

6·Investigated was the influence of the various system conditions, such as different liquids, flow velocities and jet flow diameter, etc. on the critical heat-flux density of the jet-flow boiling.

考察了不同液体、流速和喷流直径等系统条件对喷流沸腾临界热流密度的影响。

7·The calculated results of current density and heat flux on flat weld pool surface using model established in this paper are agreed with experiment.

用本模型计算出的平坦熔池表面电流密度和热流密度的分布与试验结果显示了很好的一致性。

8·The spatial distribution of the flux density is investigated by the CCD method and calibrated by heat flow meter.

采用CCD法得到了能流密度的相对分布并用热流计标定出能流密度分布。

9·The effects of the different working fluids and their filling rates, and the density of the heat flux on the heat transfer coefficient of the heat pipe were summarized from the experiment results.

根据实验结果总结出了工质、充液量和热流密度对热管传热系数的影响。

10·The thickness, surface density, heat flux and heat conductivity of spunlaced binding down web were tested under different frequency values, and the relationships between them were also discussed.

对不同分频值下水刺绑定羽绒网的厚度、面密度、热流量和导热系数作了测量，并对其相互关系作了讨论。