全部

1·The relatively low finishing temperature can lead to the coarsened grain and high retained strain before transformation.

终轧温度的降低可引起奥氏体晶粒的粗化和残余应变的显著提高。

2·The results show that, with the decrease of finishing temperature, the low-temperature impact ductility decreases gradually.

结果表明：随着终轧温度的降低，角钢的冲击韧度逐渐降低；

3·The other with different finishing temperature was tested to study the influence of finishing temperature on its low-temperature flexibility.

其中一组成分角钢又分为四种不同终轧温度，通过实验研究终轧温度对角钢低温韧度的影响。

4·As a result, higher mill entry temperatures, lower mill exit speeds at a given finishing temperature and thinner gauges in the austenite range could be realized.

结果，轧机的入口温度较高，实现了在给定的精轧出口温度较低，以及在奥氏体范围内更薄的压力表。

5·The results show that, when cooling velocity increases, the beginning temperature and the finishing temperature of phase transformation are both decrease, the grain is obviously refined.

结果表明：随着冷却速度的增大，相变开始温度和结束温度均降低，晶粒明显被细化。

6·Finishing craft should be processed under the environment of 0-40 degree centigrade temperature and less than 80% humidity.

涂饰工艺要在温度0至40摄食度，湿度小于等于80%的环境下进行。

7·Discussion focus on the influences of technological parameters like spinning temperature, spinning speed, blowing rate, oil finishing as, well as texturing on the products quality.

重点讨论了纺丝温度、纺丝速度、侧吹风风速、上油、拉伸变形等工艺参数对产品质量的影响。

8·The comparison between shortcut method calculated results and theory model calculated results showed that the temperature of hot strip at finishing rolling region could be calculated accurately.

简便计算结果和理论模型计算结果的对比表明，简便计算方法能较精确地计算热带在精轧区的温度。

9·It is essential for the design of finishing unit in spinning system to keep high enough temperature.

足够的油剂上油温度对纺丝系统上油单元的设计至关重要。

10·When applying organic fluoride water-proof and oil-repellent agent FS-506 for finishing, the effect of dosage, curing temperature, treatment duration on the fabric are investigated.

探讨使用我国自己合成的有机氟防水防油整理剂f S - 506进行防水、防油整理时，用量、焙烘温度、时间对效果的影响。FS - 506在预烘、焙烘一步法时，也能有较好的结果。