全部

1·The circuit layer is contacted with the dielectric layer and is provided at least one gasket joint.

线路层接触介电层，且线路层具有至少一接垫。

2·When the pipe joint screw, should follow the principle of diagonal twist, not one by one in order to operate, do not screw the screw die, so that the correct installation of rubber gasket.

在拧管道接头螺丝时，应遵循对角互拧的原则，不要逐个顺序进行操作，不要一次性将螺丝拧死，这样才能将橡胶垫片正确地安装上去。

3·Body and bonnet joint accurately machined. Gasket materials on page 3, details on page 13.

阀体和阀帽连接部位经过精密机加工。密封垫材料请参阅第3页，详细内容参阅第13页。

4·When the gasket is placed on the block and the head installed, tightening of the head bolts squeezes the soft metal so that the joint is effectively sealed.

当气缸垫装在气缸体上，然后装上气缸盖以后，气缸盖螺栓就压紧软金属垫，这样结合处就完全密封了。

5·In order for the flange joint to maintain a gasket seal.

为使法兰连接保持良好的垫片固定密封。

6·The leakage event of a non-asbestos gasket was taken place at the manhole flanged joint of a boiler after more than one-year service.

一台废热锅炉人孔用非石棉纤维橡胶垫片服役一年多后发生泄漏。

7·Joint sealant gasket of expanded PTFE made of pure PTFE is a continuous low density cord.

膨胀聚四氟乙烯密封胶带是用聚四氟乙烯制成的低密度密封材料。

8·One example about the decrease in diameter of ring joint gasket is reported. The reason of decrease in diameter is caused by compressive stress that make the whole gasket yielded.

报道一例八角垫直径缩减现象，指出直径缩减原因是垫圈整体受压屈服。

9·The bolt with lower stiffness accelerates the decrease of compressive stress in gasket during pressure loading, which is harmful to joint tightness.

内压加大时，刚度小的螺栓将加速垫片压紧应力的降低，对紧密性不利。

10·Mechanical joint in which sealing is obtained by applying pressure to the gasket by gland.

机械式连接采用使用压盖的方法向密封垫片施加压力获得密封效果。