全部

1·Comparative experiments of spray and packed saturators were performed with a saturator test rig.

建立了饱和器实验台，对空心饱和器和加填料饱和器进行了对比性实验。

2·Based on the principle of heat and mass exchange, a new type of superheated steam saturator is designed.

基于热质交换原理，设计了一种新型的过热蒸汽饱和器，用于热质交换设备中过热蒸汽的饱和化。

3·Under all experimental conditions the humid air at the saturator outlet approaches or has attained saturation.

在所有实验工况下，饱和器出口湿空气接近或达到饱和。

4·The method of precise temperature control by heating to the saturator of divided flow humidity generator was introduced.

采用控制加热的方法对分流式湿度发生器的增湿饱和器进行精密的温度控制。

5·The working state of gas saturator is analyzed, then the corresponding mathematical model is established and the solving method is also given.

分析了气体饱和器的工作状态，根据其热力过程建立相应的数学模型，并给出模型的解算方法。

6·Under this method the saturator has been divided along its height into several segments, each being represented by gas and water-drop modules.

该方法将饱和器沿高度方向分解为若干段，每个段用气体和水滴模块表示。

7·The washing saturator has the advantages of high heat utilization rate, low heat loss, little occupied area, little drained water, and the like.

具有热量利用率高，热损失低，占地面积小，污水外排量少等优点。

8·Applied GTAW and SMAW to weld Ammonia Saturator with emphasis on preweld treatment and controlling welding heat input, high welding quality and efficiency were reached.

在氨饱和器焊接中采用钨极氩弧焊与焊条电弧焊相结合的焊接方法，重视焊前清理和焊接线能量控制，既保证焊接质量又提高生产效率。

9·The effect of the water film resistance at air-water interface on the properties of the saturator is taken into account and a method for calculating the water film heat resistance is proposed.

还考虑了水气界面水膜热阻对饱和器性能的影响，并提供了水膜热阻的计算方法。

10·If the old AIRS is displaced in the saturator in time, the air-solubility in the saturator will increase by 10%, and the appropriate power consumption of water offering system will decrease as well.

若在溶气罐工作过程中及时置换其中的旧气，可使其溶气量提高，进而使泵水系统的能耗降低10%左右。

饱和器

1·The effect of the water film resistance at air-water interface on the properties of the saturator is taken into account and a method for calculating the water film heat resistance is proposed.

还考虑了水气界面水膜热阻对饱和器性能的影响，并提供了水膜热阻的计算方法。

2·Applied GTAW and SMAW to weld Ammonia Saturator with emphasis on preweld treatment and controlling welding heat input, high welding quality and efficiency were reached.

在氨饱和器焊接中采用钨极氩弧焊与焊条电弧焊相结合的焊接方法，重视焊前清理和焊接线能量控制，既保证焊接质量又提高生产效率。