全部

1·The change of the degree of saturation will cause the change of dynamic shear moduli.

饱和度的变化将导致动剪切模量的改变。

2·With regard to the transient calculation of internal faults, the effect of saturation is more serious since the degree of saturation is changed during the fault.

而对内部故障的暂态计算，饱和因素的影响更严重，因为在内部故障的过渡过程中饱和程度也会随时间而变化。

3·Significant correlations between dissolved oxygen content and degree of saturation and temperature, and also salinity were respectively found in the upwelling area.

溶解氧含量及其饱和度与温度呈正相关关系，与盐度呈负相关关系。

4·The pore water permeability coefficient of unsaturated expansive soil is controlled by suction, cell pressure, dry density and degree of saturation of soil samples.

压实膨胀黏土水渗透系数受吸力、围压、干密度、饱和度等因素控制。

5·Through numerical calculation, the influences of the variations of the modulus and degree of saturation of soil layer and cross-section of the pile on the response are analyzed.

通过数值计算，分析了土层模量变化、土层饱和度变化以及桩身截面变化对桩顶频域和时域响应曲线的影响。

6·The necessary condition under which shear band might appear in fly ash specimen was the relatively large density, small cell pressure and relatively high degree of saturation specimen.

粉煤灰三轴试样出现剪切带的必要条件是土样具有较大的相对密度和相对较小的周围压力，相对较高的试样和饱和状态的试样比较容易出现剪切带。

7·Based on the degree of saturation and road network density in each traffic zone, a mode is developed to show the relationship between roadway network reliability and the impact factors.

以交通小区路网饱和度和路网密度为基础，建立路网畅通可靠度及其影响因素的多元关系模型。

8·The tool also can be used for evaluation of formation oil saturation and formation flooding degree perfectly in an old producing well.

在已投入生产的老油井中，能够较好地评价储层的剩余油饱和度及水淹程度；

9·Correlation between relative humidity and degree of capillary saturation derived in the laboratory is not suitable to the service life prediction.

混凝土保护层孔隙水饱和度是混凝土结构钢筋腐蚀寿命预测模型的关键参数。

10·Through research on project evaluation targets system, saturation degree, average speed, traffic density and average travel delay of works sections are defined to be evaluation targets.

通过方案评价指标体系的研究，确定了施工路段饱和度、施工路段平均车速、施工路段交通密度以及施工路段平均行程延误四个指标作为评价指标；