全部

1·This paper introduces how to use the optimum transfer function to design nuclear reactor power controller.

介绍用最优传递函数方法设计反应堆功率控制器的方法和步骤。

2·As one of key control systems in the nuclear reactor, the nuclear reactor power control system is complicated, and requires very high level of reliability.

功率控制系统是反应堆的一关键控制系统，系统复杂，可靠性要求高。

3·This paper presents the modular modeling of movable boundary in straight tube Once-Though steam generator (OTSG) for sodium cooled fast reactor power plants.

研究了钠冷快堆电厂直管式直流蒸汽发生器可移动边界的模块化模型。

4·The control rods are used to implement quick regulation of the reactor power and emergent shutdown of the reactor in pressurized water nuclear power station.

压水堆核电站依靠控制棒实现反应堆功率的快速调节和特殊情况下的紧急停堆。

5·This paper introduces the reactor power regulating system of CEFR and the application of Programmable Logic Controller (PLC) on the engineering test prototype.

介绍了CEFR反应堆功率调节系统及可编程控制器在工程样机中的应用。

6·The power regulating function of system can overcome the disturbance and maintain the stability of the reactor after reactor power reaches the fixed value of power.

到达设定的功率定值后，系统可投入自动调节，克服扰动，维持反应堆稳定运行。

7·The reactor power setback logic initiated at 2 percent power while reactor power was being raised from a lower power level in preparation for Heat Transport System (HTS) warm2up.

在反应堆从低功率级开始提升以准备热传输系统（HTS）升温的同时，反应堆功率慢速降逻辑于百分之二功率上启动。

8·Thus the operation safety is ensured and sensitivity increased; added UPS as backup power supply ensures safe shutdown and the indication of the reactor power at reactor shutdown.

增设UPS不间断电源作系统安全电源，保证可靠停堆与在反应堆失去全部电源情况下指示堆功率。

9·The space curvature of neutron density of this solution is changed according to the changes of reactor power, so it is more precise than the analytic solution of point reactor model.

此解的中子密度空间分布曲率是随堆功率变化的，因此它比点堆模型方程的解析解精确。

10·The controllers guarantee both stability and performance index in the operating region, the controlled process is that the controller is automatically adjusted along the reactor power.

这几种控制器即可以充分保证系统的稳定性，又满足了在控制区域的性能指标，其控制过程是控制器按照反应堆功率自动调节。