全部

1·Keeping pouring quality would prevent the ingot steel from forging bursting.

为避免此类缺陷产生，必须保证钢锭的浇注质量。

2·A steel mill's ingot goes into a sedan or a skyscraper, but not both.

炼钢炉炼出的钢材可能用来造小轿车或者摩天大楼，但不可能一块钢材两个都造。

3·Cargoes like grain, crude oil, ingot aluminium, steel and automobiles are shipped bulk or grains, with only minimal parking.

像谷物、原油、铝锭、钢和汽车等货物以散装形式运输或只进行最低程度的包装。

4·This paper has theoretically studied the effect of blowing Ar into molds on improving killed steel ingot quality.

本文从理论上分析了采用锭模吹氩对提高镇静钢质量的作用。

5·A new method to simulate directly and predict the formation process of shrinkage cavity, its final shape and position for steel castings and ingot was proposed using computer.

提出了可用计算机直接模拟钢铸件、铸锭缩孔形成过程及最终形状和位置的直接模拟法。

6·So less gas is. given off in the mould than with rimming steel, but enough bubbles form at the top of the ingot to counteract most of the shrinkage.

所以，在钢锭模内析出的气体没有沸腾钢多，但又在钢锭头产形成足够的气泡抵消大部分钢的收缩。

7·It is suitable for the grinding of steel ingot, removing burrs of casting, precision grinding of stones, cutting and polishing. But it should be kept away from alkaline solution.

适用于磨钢锭、铸件打毛刺、石材表面精加工、切割、抛光等。但该类磨具不抗碱性溶液。

8·In seawater and fresh water, the performance of ingot and 35 steel was measured by constant current experiment, and then their anodic polarization curves were drawn.

利用恒电流试验测试了工业纯铁和35钢在海水和淡水中的牺牲阳极性能，利用电流阶跃阳极极化法测试了二者在海水和淡水中的极化性能。

9·The ingot annealing technology in some alloying steel plant have been investigated.

调查分析了一些特殊钢厂的钢锭退火工艺规范。

10·As a result, it is possible to get a better discharge flow in the feeding zone of the ingot mold where the discharge device of molten steel is placed, in addition to less turbulence.

结果，除了湍流更少之外，还可以在锭模的进给区域获得更好的排放流，熔化钢铁的排放装置位于该进给区域。