全部

1·The minimum dry film thickness of coating shall be 100 microns.

最低干膜涂层厚度应为100微米。

2·Objective: To test and analyze density of medical dry film varying with temperature.

目的：测试与分析医用干式胶片密度随温度的变化。

3·Does the stripping module contain a filtering system for the removal of the dry film resist?

剥膜机是否有过滤系统以去除干膜膜屑？

4·The dry film has excellent properties, such as higher hardness, fast dry and other good properties.

漆膜具有高硬度、快干性及其他良好性能。

5·There is a direct relationship between the dry film thickness and the solids by volume of the paint.

在干漆厚度与涂料大量的固体物之间确有直接的关系。

6·The influences of microgel on the application, film-forming property and dry film properties are discussed.

讨论了微粒凝胶对涂料施工、成膜性能的影响以及应用。

7·And because the surface is so uneven, the dry film thickness on the 21 panels measured exhibited this wide range.

且由于表面是这么的不平滑，所测量到的这21块钢板上干后的漆膜厚度才会显现出这么大的幅度。

8·PP plastic paint general spray 2 times, spray gun to smooth, the dry film thickness of the primer is generally 15-25 microns.

PP塑料漆一般喷涂2遍，喷涂时走枪要平稳，该底漆的干膜厚度一般为15 - 25微米。

9·Strip Resist: The hardened dry film is stripped from the copper leaving the desired copper pattern reproduced from the artwork.

去膜：蚀刻后将抗蚀层干膜去除，得到所需的裸铜电路图图。

10·If the tested sample is in powder phase or dry film, it will be tested by following stipulated test method to determine its content.

粉末状样品或干涂膜样品，按规定的方法测定其含量。