全部

1·Connect the cold water supply line and hot water outlet lines using elbows, nipples and unions as shown in the diagrams.

通过顶部玻璃纤维绝缘层可以连结管道和电源。使用如图所示的弯管、螺纹接头、管道接头连接冷水进水管和热水出水管。

2·Series 100xl furnished with test lever and extension thermostat for installation in the hot water outlet line or directly in the tank tapping.

系列100 XL配置测试杆和加长温控杆，适用于安装在热水出水管路上，或直接安装在容器的螺纹孔上。

3·The test results have proved that the flow rate widely varied and the pump efficiency is high when the pump outlet line structure was altered and the outlet pressure was controlled in a special limit.

试验结果表明，改变泵出口管线结构，使泵出口压力在一定范围内工作时，流量变化大，而且泵效率较高，可以作为泵调整参数的一种手段；

4·A special treatment is made in outlet boundary in which the subsonic and supersonic flow exist commonly. Block-Line-Gauss-Siedel method is used to solve THD differencing equations.

对离散方程采用线超松驰方法迭代求解，在亚音速与超音速气流共同存在的出口边界分情况进行了处理。

5·For the entire line, the number of branch circuit should not be too small, generally should be light to go all the way, air conditioning to take the two road, the outlet to go three to four.

对于整个线路来说，分支回路的数量也不应过少，一般应该是灯走一路、空调走二路、插座走三至四路。

6·The inlet port is connected to the pressure line in and the outlet port should be connected back into the non-pressurized reservoir.

进气口连接线的压力和出口港口应连接到非加压水库回来。

7·A proper drain line connected to the valve outlet and run to a safe place of disposal must be installed.

必须安装一个适当的排泄管道，连接阀门的出水口，并且流向安全的地方。

8·If do big specification line, two outlet open, so that strengthen the cooling effect of the copper wire.

如果做大的规格线，两个出水口都要打开，这样加强铜线的冷却效果。

9·The discharge line must be the same size as the valve outlet, and must pitch downward from the valve to a safe place for disposal.

排泄管道必须与安全阀出口具有相同的口径，必须从安全阀的下方接到安全排放地点。

10·One outlet is in line with the inlet, and the other is offset 30 degrees.

一个出口与进口相一致，另一个呈30度角。