全部

1·Dispense all of the thermal grease from the syringe to the center of the Integrated Heat Spreader surface.

把全部散热油膏从注射器中注入到集成式导热器表面的中心。

2·LED chip and heat sink for thermal connection to solve the thermal grease, thermal paste difficult operation, uneven coating, plastic overflow problem caused by defective products.

用于LED芯片和散热器导热连接，解决了散热膏，导热膏难操作，涂不均匀，溢胶造成不良品的难题。

3·It was found that RTV silicone rubber or silicone grease had the maximum thermal conductivity and the lowest viscosity, when the filler particle sizes distribution was proper.

发现当粒径分布适当时，可得到导热系数高、粘度低的室温硫化导热硅橡胶及导热硅脂。

4·The influence of static thermal degradation on colloidal performance of Lithium-Calcium base grease was studied by the centrifugal oil separation test, dropping point test and acid number test.

利用离心分油试验机、油浴滴点测定仪和酸碱滴定仪分别考察了静态热老化对锂-钙基润滑脂胶体性能的影响。

5·The principle and experiments on the measurement of grease stain in petroleum pipeline using the thermal neutron gauge were reported.

叙述了利用热中子透射计测石油管道内油垢厚度的原理、实验和结论。

6·Experimental results indicate that the thickness response of grease stain is sensitive and the thermal insulating layer has no too much effect on the obtained results.

测量结果表明：油垢厚度响应曲线是灵敏的，保温层对测量结果影响不大。