全部

1·Pre and post treatment arch width was measured.

比较治疗前后牙弓宽度变化。

2·Pretreatment, bluing and post treatment of this process were introduced.

介绍了前处理、发蓝及后处理工序。

3·The effects of post treatment technology on the properties of the fuse were studied.

本文着重研究了后续处理工艺对保险丝性能的影响。

4·The low limb' s MFT: There are signification difference pre-post treatment in the three groups.

对上肢功能的影响：治疗前三组上肢功能评定，差异无显著性意义。

5·We survey patients pre and post treatment, and have had excellent results and compliments from all patient groups.

我们调查的患者治疗前和后，并取得了很好的效果，受到称赞。

6·In addition, some problems relating to post treatment, passivation process and waste water treatment are also discussed.

最后还研究了镀后的钝化处理工艺及废水处理方面的一些问题。

7·Selection of paste, alkali, urea, resist salt S and sodium sulfate, as well as the post treatment conditions are discussed.

讨论了针织物上浆处方中糊料、碱剂、尿素、防染盐S和硫酸钠的选择及后处理工艺条件；

8·The effect of Al content, direct current negative bias and post treatment on the friction coefficient of the films was studied.

在此基础上讨论铝含量、直流偏压及后期处理对薄膜摩擦系数的影响。

9·The post treatment can improve deformation and surface stress state, refine microstructure and increase hardness of cladding layer.

后热处理可改善变形和表面应力状态、细化组织、提高硬度。

10·The processes of rapid forming solid parts by laser sintering ceramic powder include laser sintering and second sintering post treatment.

激光烧结陶瓷粉末快速成型三维零件的过程包括激光烧结和二次烧结后处理两个步骤。

后处理

1·Selection of paste, alkali, urea, resist salt S and sodium sulfate, as well as the post treatment conditions are discussed.

讨论了针织物上浆处方中糊料、碱剂、尿素、防染盐S和硫酸钠的选择及后处理工艺条件；

2·The processes of rapid forming solid parts by laser sintering ceramic powder include laser sintering and second sintering post treatment.

激光烧结陶瓷粉末快速成型三维零件的过程包括激光烧结和二次烧结后处理两个步骤。

3·A new method for post treatment of porous silicon, sulfur passivation by microwave plasma assistance in vacuum, is reported in this paper.

报道了对多孔硅进行后处理的一种新方法，即真空中微波等离子体辅助的硫钝化处理。

4·The paper compared the Chinese rice wine and Japanese sake in material, technology of fermentation, post treatment, content of amino acids, physical and chemical indexes, and so on.

该文从原料、发酵工艺、后处理、氨基酸含量及理化指标等方面比较了中国黄酒与日本清酒的差异。

5·Influences of parameters for oxidizing process, pre and post treatment procedures and material status of brass substrate on quality of chemical conversion film on brass were described.

介绍了氧化工艺参数，前、后处理工序，黄铜基体材质状况等因素对黄铜化学转化膜质量的影响。